...new Mr. Coffee has slowed down in it's brew time. It takes nearly 40 minutes to brew a half of a pot. Why :( If you have hard water, minerals may have built up in the unit, slowing down the flow. You ...
...new brewed pot of coffee. If you have more than 10 grains of hardness you may consider frequent vinegar usage or a specialized acid for tank and element cleanup. Just be sure that when you are done ...
...new, clean, paper filter and turn the unit on and run a plain pot of water. This will help to clean out any remaining residue and clear the unit of the vinegar taste and odor. Now you're all set to ...
...residue/ grounds are removed and the little cup fits perfectly into the well. It is the perfect fit of the two that allows the perc-ing cycle to occur. If the pot is not heating, or these cleaning ...
...residue off the inside of a glass coffee carafe. Does your pot have hard to reach areas? Use a wooden chopstick with a paper towel to get in there. You can put ice cubes and a little water(enough so ...
...residue off the inside of a glass coffee carafe. Does your pot have hard to reach areas? Use a wooden chopstick with a paper towel to get in there. You can put ice cubes and a little water(enough so ...
new. The residue is not from our filtered water. Thoroughly wash the pot and the basket with a good oil/grease remover (detergent) such as DAWN dishwashing liquid. Then run White Vineger/Water (50/50)
Question about BrewStation Deluxe 47474 12-Cup Coffee Maker
...residue to be removed. Try to have a look whether there is a limestone layer built up on the element. That will slow it down, while most probblems will stop it alltogether. Remove by leaving white ...
everything. a particularly dirty machine run through twice. Just be sure to run clean water through a couple times to rinse any vinegar residue out of the machine. It will be like new again. good luck
Question about Brewer a: Mr. Coffee K-Cup
may be dirty from coffee residue and needs to be cleaned. The entire assembly turns and lifts out but be careful as the piercing needle is SHARP. After cleaning, try a new k cup and see if it works ok
Usually answered in minutes!
1,392 Questions
801 Questions
725 Questions
572 Questions
453 Questions