Questions & Answers for: Chevrolet Equinox how do reset service light

Question about 2005 Equinox

1 Answer

...reset the computer. I have been disconnecting the battery terminal. turn your ignition switch on, do not start. Forcefully press the accelerator 3 times, the light will blink. Once it blinks and goes ...

Ad

Service Lamp Reset How do I reset the instument panel service lamp after an oil change? Turn the ignition to run. Within three seconds push the gas pedal to the floor three times. Turn the key to off,

Ad

reset oil service light Chevrolet Equinox. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd,

reset oil service light Chevrolet Equinox. If you like to reset any maintenance oil light after an oil change. Or reset check engine light, airbag light, inspection key or insp errors when maint reqd,

Question about 2005 Equinox

1 Answer

...service life and replacement will be necessary. You may try to reset it to by removing the positive battery connector, letting it sit for at least 5mins. then reconnect it again. This will reset the ...

Question about 2005 Equinox

1 Answer

...service interval light. This light has to be manually reset when the oil is changed. In some Chevrolets you turn the switch to the on position, push the gas pedal to the floor five times in a steady ...

Question about 2007 Equinox LS New Cars

1 Answer

service light came on yesterday in the snow and will not reset with the controll button if it not reset it is a permanent fault and you must connect the car to a diagnosis machine to find out what the

...service light, not to be cofused with the ck engine light, came on. I then reset the light by depressing the gas pedal three time as you would do to reset it after oil change. The vehicle ran ...

Question about 2007 Equinox LS New Cars

1 Answer

...service that will do this for you, all you have to do is drive there and ask them to scan your check engine light. They will grab their scan tool and ask you to lead them to your vehicle which they ...

Question about 2008 Equinox

1 Answer

...the "service stabilitrak" light came on and i have no power steering Try disconnected the ground cable from the battery, wait ten minutes and hook it back up. This should reset

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Manuals & User Guides

Loading...