Question about 1999 Odyssey
...reset procedure. See SELF-DIAGNOSTICS - INTRODUCTION article. Start engine and run at 3000 RPM with no loads and transmission in Park or Neutral until radiator fan comes on. Test drive vehicle at ...
reset the codes and the next day the P0135 & P0141 came back. The O2 heat uses a compare to coolant temperature, could this be a coolant issue. Any suggestions are greatly appreciated A code P0135
...reset if the battery is disconnected.. most tests allow only one monitor missing,and not the catalyst . A drive cycle will have to be done to set the monitors. Typically cold start coolant temp less ...
...purge flow fault. I had my check engine light reset. It has now come back on again. Do you think it's the same issue, because I never checked it out the first time? What does that code mean? You have ...
RESET CAT AND O2 MONOTOR Here is the info NOTE: The ignition key must not be on prior to the cold start otherwise the heated oxygen sensor diagnostic may not run. 1. As soon as the engine starts, idle
...reset your computer with key off and test jumper removed and disconnect battery for a few seconds. Then reconnect battery, sit in car, put right foot on brake pedal and start engine without touching ...
Purge Flow Switch Malfunction. It could be part of the vacuum circuit that purges gasoline fumes from the fuel tank. Have you reset it to see if it comes back? I read from other sites that its the gas
Question about 1995 Accord
Purge Flow, P0401 EGR Flow Insufficient Detected and P0725 Engine Speed Input Circuit Malfunction. On the way home from the re-test my car kinda acted like it was gonna stall (but it did not stall). I
Question about 1995 Accord
...reset defect not cleared connection checked ok The code is for a large leak in the EVAP system such as a loose or missing gas cap. But it could also mean a loose or missing hose to the canister ...
...reset but comes on again later. Already replaced cap with Honda cap. no year or model car told just honda. learn to scan the PCM (and check fuses) EVAp has many many failure modes and the PCM is ...
Usually answered in minutes!
2,998 Questions
2,681 Questions
1,631 Questions
1,636 Questions
1,570 Questions