Questions & Answers for: how do i reset a check engine light on a 2005 dodge ram

...light on the check engine light is on in my 2005 dodge ram 3500 diesel. how do I reset it? you need to use a scanner. disconnecting the bat ground will work on most codes. it's safer to use ...

...located in the speedometer cable with a small screwdriver the light comes on only because it reminds you to check the egr based on mileage driven an autoparts store can also reset the light for ...

...check engine light was on and I am unable to get boost pressure from the turbo, wont go above 5psi. I made sure all the clamps were tight and everything appears to be hooked up properly. its a 2005 ...

...reset? do not suspect computer. 1 the new battery may not have been charged from the store so would need to be charged before use, charge new battery on a charging set and see if this resoves the ...

...reset the check engine light. Oh, and depending on what tripped the check engine light, Chrysler has a funny way of just leaving the light on for a set period of time. If the problem is resolved the ...

reset the computer, any other idea thats a big loss from 20-22! Sounds like the engine is running in 'limp in' mode, which should have turned on the check engine light. Take the truck to Autozone or a

Check Engine Light will illuminate on the dash. This light can indicate a variety of problems. Ironically, only several codes pertain to the actual engine in your truck. Many of the codes can indicate

reset check engine light i went and got the code and found out the problem and fix it a thottle sencer and hook the battery up and drove the truck now the check engine light is back on what do i do to

...reset the check engine light on my 2005 Dodge Neon? Go to your local auto parts like autozone and they will reset for free or disconnect neg side of battery for a few mins. hook it back up it should ...

...reset check engine light 2005 dodge ram 3;7 litre Check and make sure All fluids are Full, oil, brake, trans, etc... they all have low sensors tied to check engine indicator, then disconnect the Pos+ ...