Question about Power Center for Aqualink Rs
Aqualink rs system is shut down. Nothing seems to have any my system is shut down. Nothing seems to have any power? But the tester shows power into breakers? Is there some sort of reset for the system
...aqualink RS PDA (model 8265). The equipment was recently installed and has worked for me the first time I used it a couple weeks ago. It will not connect to the power center this time. The display ...
Question about Aqualink Rs4 One Touch Control System Control System
...Jandy aqualink RS handheld went out when we lost our electricity...Now we cannot open main menu, the window says "waiting", how do we jump start the system? GO TO THE MAIN PANEL AND RESET THE ...
...aqualink RS8 is reading 6700 REV C in the display window and ALL of the display lights are flashing on. I have tried the reset button and pushed the menu and cancell buttons. Nothing seems to work. ...
aqualink rs4 is completely lit with the message 6700 rev c. any suggestions? i tried reset check for cut wires or shorted wires at 4 pin red plug
How do I reset my Jandy Aqualink RS reset button on top left
...Aqualink RS PDA? My old control board died. I purchased the Aqualink RS PDA board with remote to replace the old board (it was cheaper and came with the PDA). Everything is up and running fine with ...
...aqualink Turned out after a factory reset mine was set to 0%. It was annoying having to go through every setting but in the end I learned a lot about the system. make sure 4 pin plug from board on ...
Aqualink RS does not appear to want to communicate with the heater. Attempted use of reset button, but did not fix my issue. Help!! try to put heater off remote and try manual if works bad temp sensor
...reset" button on the outlet. Check the transformer: The AquaLink RS requires 24 volts AC power to operate. If the transformer that converts your home's AC power to the 24 volts required by the ...
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions