Questions & Answers for: Mitsubishi replacing starter

Need to replace the starter on the 97 mitsubishi Diamante, how hard is it to remove and replace ? How hard is it to replace the starter in a 97 diamonte ? To replace the starter you need to; ) Note if

starter selenoied try replacing the wireing to your starter and when you make the connections put some dielectric greese on the connections to prevent carrsion you may also have a bad relay replace it

will not crank , can jump at starter , but want star with ignition switch . Replace the ignition switch... But! If you are turning the key and you are not getting anything from the starter, then ...

car will not start, turn key in ignition and nothing but click, click! I checked battery at autozone. The battery is only 2 months old and checked out fine. The charge reading was 100% full strength ...

...replacing the solenoid. If that doesn't solve your problem, you'll have to replace the starter.Check back with me if you require any further assistance in removing or replacing the

wont start as if battery is weak but battery is good. battery is good but starter wont crank At the starter ck. the small wire for 12v. when the key is turned to start,if 12v. are there replace ...

replace old starter with new but still car won't start replace old starter with new but still car won't start Have you checked the stater solenoid (located on the top of the starter motor)

...replacing wire that goes to starter, replaced starter, replaced battery. Checked fuses, inside car and underneath hood. Alternator has been replaced. I am now trying to replace the ignition switch. ...

i replaced the altenator and starter it ran for a month now wont start and just clicks whats wrong Battery not holding charge, not enough voltage, or the starter has went bad again. Check battery ...

how to replace starter motor remove starter motor Remove the battery connection ground, lift the vehicle with a jack on the side starter is on and block the under the frame for safety, take the ...