Question about 1993 Bronco
...FORD 302 EFI V-8 USING EXPLODED VIEW DIAG CRACKED METAL TUBE FROM INTAKE MANIFOLD TO UPPER FRONT RIGHT SECTION OF MOTOR (EXTERNAL) Sounds like it is the tube to part of your emissions equipment. It ...
...ford expedition rough idle allready replaced o2 egr now what do i try First, go to Autozone or Oreillys for a free scan. Then get a gasket for the airhorn to intake manifold. You need to undo the 8 ...
...ford f250 diesel in water . The over flow fills up with diesel when running over 4 hours . Bad intake manifold gasket, head gasket, manifold pre-heat gasket, or any combination of them. Fuel injector ...
...manifold on a 1991 ford bronco 302-v8 start by removing nuts from exhaust pipe on the underside, then remove the 8 bolts that hold manifold to engine and pull it up. make sure when reinstalling you ...
ford focus 1.6 16 v there are rubber mounting underneath the car, remove there. follow the exhaust pipe to the engine, loosening any bolts and nuts holding the exhaust in place. the exhaust pipe meets
...manifold that is very close. So becareful when inspecting. Its avalible from Ford for aproximatly $20.00. have fun and tell the dealer to shuv it. try disconnedting the negative battery cable, ...
...7 and 8 randomly mis-firing and I have replaced plugs, wires, and coil packs. What else would it be? COULD HAVE CLOGGED FUEL INJECTORS OR INTAKE MANIFOLD VACUUM LEAK AT CYLINDERS 7 AND
Question about 2000 Crown Victoria
...8 bolts hold the airhorn to the intake manifold. Under the airhorn, and under its gasket is a channel which needs to be cleaned for top performance.It takes a $10 gasket, and about 1 hour of ...
...manifold if you replaced every thing what did spark plug look like, did you do a spark plug diagnosis, could have wrong spark gap or faulty spark plug.you need to see if pcm is firing 8 fuel injector ...
Question about 2000 F250 Super Duty Crew Cabs
Where is the pcv valve on 96 ford bronco located if it a full size bronco with a v-8 it will be located in the center at the back of the intake manifold be sure and replace the grommet as well
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions