Question about 2004 PT Cruiser
crank sensor because everytime we leave the car outside and not in our garage we have noticed that when we get a heavy rain the car will not turn over, it will make the click noise but, saddly it wont
crank sensor on 2003 jeep grand cherokee how do i replace crank sensor on jeep its easy, its underneath the passenger side located halfway up the transmission bell housing unplug, u will need to use a
...crank/cam sensor faults 2004 PT Cruiser no turbo. Engine died at hwy speed crank/cam sensor faults will not start o1 cruiser spit and sputter go down rd put cam sensor and crank shaft sensor on ...
CRANK SENSOR Use the fluke meter. Unplug the sensor, and backprobe the connector. Theres 3 slots, you want A and B on the connector going TO the sensor- not TO the engine. Normal resistance is 200ohms
...replacing the Crank Shaft Position Sensor, I just had a Dodge vehicle with the same problem but in reverse, it kept saying Crank Sensor but it turned out it was the Cam Sensor. Good Luck. Go back to ...
Question about 2005 PT Cruiser
crank patterns. If a pattern is missing, suspect a bad sensor or a slipping tone ring. Remove the cam gear and the crankshaft harmonic balancer and inspect the tone rings for proper alignment and make
crank sensor and cam shaft snnsor and it ran like a scalded dawg for about a week and then it started conling out on me today after a 140 mile trip. my mechanic cant figure it out and i'm about out of
Question about 2002 PT Cruiser
ran rough, now cranks, no start,replaced coil,cam and crank sensors. What next??? so, i guess, you never seen a scan tool> you crank engine and you get DTC errors telling you what failed? crank for
Question about 2005 PT Cruiser
...replacing crank sensor code for crank sensor came on replaced sensor but light came back on with crank sensor code The check engine light is still on because the fault identified by the computer was ...
...at the PCM? What pins do I check for voltage? Sounds like it has jumped time.....Timing Belts must be serviced every 60,000 miles.....The crank sensor must communicate with cam position
Usually answered in minutes!
1,198 Questions
1,147 Questions
1,007 Questions
816 Questions
677 Questions
