Question about 2008 Avalanche
brake switch in order for my video to play isn't there a way to bypass the parking brake so my video plays anytime i want gm navigation radio for my chevy avalanche get the lockpick. gen5. about $249.
...if the turn signals work,and the flashers,the problem,is most likely in one of the flashers,they are stuck,the flasher. It could be a short in the brake light wiring. Make sure you have a good
...brake light switch under the drivers side mounted on the brake pedal it may have broke or come out of adjustment in any case you could push the switch in by hand and tape it as to not drain your ...
...lights won't turn off 2008 chevy aveo brake lights won't turn off CHECK FOR YOUR BRAKE LIGHT SWITCH IT IS LOCATED BEHIND THE BRAKE PEDAL UNDER THE DASH. FOR A TEST DISCONNECT IT AND
Question about 2008 Malibu
...Brake light Problem when pedal up or when key on brake lights are on Disconnect the brake light switch under the dash above the pedal, if the brake lights go off adjst or replace the
...bulbs all seem to be in good shape. do you have lights on in the back if you put on the headlights if you have lights in the back when this is done check the brake light switch on the brake ...
Question about 40-cr20 2006-2008 Chevy Cobalt Lt Car Antenna Cable Audio Radio Stereo
...brake light doesn't work. bulbs are fine and replaced brake light switch, still won't work. tail light brake lights work fine. 2008 Chevy Cobalt center brake light won't work, other two brake lights ...
Question about 2002 Avalanche
...brake light sensor back the brake pedal of a 2002 avalanche Get a replacement from a Chevy dealer and it should be obvious as to how it is installed. First check to see that the one you have is just ...
Question about 2002 Avalanche
High beams on my 2004 Chevy Avalanche not working any answers? Replace the turn signal switch. All the exterior lights run threw it except the high mount brake lights.
Question about 2008 Avalanche
2008 chevy avalanche. Both of my rear windows will roll down with the back switch but will not roll up with the back Switch. I can use the driver switch to roll them up . What could it be???. Switches
Usually answered in minutes!
4,236 Questions
3,749 Questions
3,350 Questions
3,279 Questions
3,219 Questions