...replace thermistor still the problem occur since you need to reset even after you replace a new one..try reset again. It's s thermistor error. A new thermistor will solve the problem. Where could I ...
...them. Try not to contact the heat roller itself as you may scratch it and then it will have to be
...thermistor disconnected or defective power supply not within rated range (15% or more below rating). Try cleaning or replacing the thermistors and reset code in service mode. you have an over heat ...
°C, for 6seconds continuously. - Solve - 1. Check if the fusing unit is properly installed. 2. Check if the thermistor connector is properly connected. 3. Replace the thermistor if it is deformed
...thermistor fails ore contaminated or poor connecton finellay power supply bord defective most of this cases we find thermistor failure first replace the thermistor 90% your problem solves- ...
...replace the thermistor with the same one and if you check heater unit and there parts lamp thermistor are ok then reset the heater code press all clear (yellow key) press (1) and (0) and (7) from key ...
...replace the Thermistor? What about the Fuser Roller? The Thermistors start to work bad because of the toner crust in the Fuser Roller. I advise you to change not only the Fuser Roller but also the ...
...Thermistor is broken, or out of place 4. Fusing temperature –15% less than the regular input voltage Might be a one time failure you can reset. Access service mode and reset the code then ...
Question about Aficio SP 5200DN - Printer - B/W - duplex - laser - Legal, A4 - 1200 dpi x 600 dpi - up to 47 ppm - capacity: 650 sheets - USB, 10/100Base-TX, d
...fusing lamp Install the thermistor properly. Replace the thermistor. Replace the fusing lamp NOTE: This SC cannot be reset by turning the power off and on. SP5810-01 can reset this
Question about Aficio SP 5200DN - Printer - B/W - duplex - laser - Legal, A4 - 1200 dpi x 600 dpi - up to 47 ppm - capacity: 650 sheets - USB, 10/100Base-TX, d
...(end) is firmly connected. 2. Replace the pressure roller thermistor (end). No. Type Details (Symptom, Possible Cause, Replace the thermistor (center). • Clear this SC by executing
Usually answered in minutes!
629 Questions
382 Questions
267 Questions
215 Questions
218 Questions