...Replace the Pick roller and the Brake roller and see if the error is resolved. Check the consumable counter in the software operation panel or in the built-in Maintenance mode. When the counter ...
...replace this roller? Thank you for the help, Dave The problem is not just to roll over, be changed and separation pad. These two components change very easily and boxes that are delivered and ...
...Roller and US Sensor FX status. you may have to replace any of the above, if damaged or worn off. Hope the above information is helpful. Please check your device first and get back to me. Thank you. ...
We have replaced the pick roller and the scanner properties are not allowing us to reset the pick roller count (the clear option is not available as per pages 105 or 112 of the operator's guide). ...
Question about fi-5900C Pass-Through Scanner
Roller 2 is installed left-right reversal. Check the same too. If the issue still persists, then you may have to replace the sensor. If the above steps do not help, then you are recommended to contact
replace the Brake Roller. If the above information doesn't help, please contact an authorized FUJITSU scanner service provider or the dealer where you purchased the scanner. Hope the above information
...Roller count. If the counts exceeds the suggested replacement cycles, then you you may have to replace the same. Pls refer to page-99 of the getting started guide supplied with your scanner. Hope the ...
...replace Pick roller or Brake roller see if the error is resolved. 6. If the issue still persists, then you are recommended to contact the nearest Fujitsu service center for further assistance. Hope ...
...Replace the Pick roller, the Brake roller and the Chute roller, and see if the error is resolved. - Check the consumable counter in the software operation panel. When the counter exceeds the values, ...
...jam error, you need to check the condition of pick,separator,brake rollers, feed and pinch rollers. Replace the rollers if required. Hope the above information is helpful. Thanks & ...
Usually answered in minutes!
109 Questions
61 Questions
76 Questions
33 Questions
26 Questions