Questions & Answers for: Isuzu replace a plug

...Spark plugs fouling > Clean or install hotter type plug Spark plug(s) insulator nose leaking > Replace Fuel injector(s) defective > Replace Powertrain control module faulty > ...

Ad

Question about 1998 Rodeo

1 Answer

...plug make sure you replace the seals on both plugs.Remove the fill plug and pump f;uid in untill it comes out. With the vehicle level run the vehicle until warm shifting through foward and reverse ...

Ad

...replace spark plug seals on 1995 Isuzu 3.2? the metal seal under the spark plug should never be replaced, just replace plugs if leaking (rare) , but if oil is leaking into the 'plug tube' then tappet ...

replace the wire, go to the next plug. Now,, I don't know why you are changing plugs, Most cars go over 100k miles without even thinking about them, I have changed my plugs once in 15 years, 94 rodeo.

...plug and replace it. I'm not sure if bearings were damaged. If I replace the plug I will be able to tell if there is in engine knocking. freeze plugs are only used in water locations . all oil ...

...to a Honda dealership for repair. It ran great for 3 years and now I am having the issure again. I replaced the spark plugs and wires. New air filter. Cleaned the mass air flow sensor. It looks as

Question about 1998 Rodeo

1 Answer

...plug, and you should replace that coil pack. Also check the spark plugs for wear and the ignition wires should be replaced if they are over five years old and stock wires will usually have a date on ...

Question about 1987 Pickup

1 Answer

...they would change plugs, wires, rotors for $300.00 seemed high. When I asked to just have plugs replaced, they said it has 8 plugs to replace. When I questioned them on that they then said if it ...

plug socket as well as a long extension to replace spark plugs.That you can get at local auto part stores.Plugs are on either rocker cover....there are 3 ign coils on each rocker cover that need to be

Question about 1993 Amigo

1 Answer

...replace new plug with new gasket washer but dont over tighten when replacing . THE other way is to tap it with a screwdriver and hammer but only lightly and on the plug only. and do it after a run so ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

2001 Isuzu Rodeo
2001 Isuzu Rodeo

832 Questions

1999 Isuzu Rodeo
1999 Isuzu Rodeo

814 Questions

2000 Isuzu Rodeo
2000 Isuzu Rodeo

819 Questions

1998 Isuzu Rodeo
1998 Isuzu Rodeo

720 Questions

1995 Isuzu Rodeo
1995 Isuzu Rodeo

623 Questions

Top Isuzu Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Are you an Isuzu Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...