Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...Oil pump replacement? Need repair manual or parts breakdown. Thanks Warren Also make sure that where the oil is pumped against the side of the bar that the oil port (little hole) that feeds oil into ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...replace it. I tried my chainsaw several days later and no oil on chain. I was angry and I decided dismantle the clutch and pump. With my and i turned the small pump and oil sink of it... i ...
...I've replaced the output oil hose.The oil backs up behind the plate. Is there a way to insure a seal to the oil pump? check that the oil gallery in the bar are clear.blow out with air if you have
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...that you have a problem with the oil pump . Try readjust the oil flow screw located by the sprocket under the machine . If this does not help the best choice is replace the oil pump .Hope this ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...replace the oil pump (part # 537 10 55-02 which will cost you about $35.00) Hope this help Check your operators manual carefully many new Huskys have a 3 position oiler with 1 being the least and 3 ...
...oil pump. Changing back to the spur sprocket fixed the problem. Is there a rim sprocket that will work on this saw? I'm not aware of a rim sprocket that will work with the saw. Sorry there is no ...
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
...oil pump, the adjuster is a slot head screw acessed through the bottom of the crankcase, try increasing the flow first, if no better, you need to remove the clutch and sprocket to gain acess to the ...
...oil replaced oil pump and worm gear and still little or no oil to chain. whats left? Check the oil lines to make sure none of them are clogged and that the oil holes in the bar aren't
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
oil. any fixes or better parts. The hose is leaking. You will have to replace the hose. You do not have to disassemble the saw in half as many seem to think. Just some of the parts that are in the way
Question about , No.455 Rancher, 20" Gas - Powered Chainsaw
oil tank to replace the oil that you should be using. With the cap on the oil tank (with oil in the tank) I put air pressure against this screen. With the oil pump removed I will soon get oil to start
Usually answered in minutes!
1,998 Questions
1,006 Questions
778 Questions
1,057 Questions
700 Questions