Question about Laars LX Pool Heater / 400,000 BTU / Natural Gas
...Jandy LX pool heater, and Im getting a low pressure reading which is prevent the heater from starting. Water flow is fine and fiter is clean. Do I need to replace the pressure switch? I had this ...
Next, cycle the ignition sequence until the air is out of the gas line. If it will still not fire, replace the gas valve
Question about Laars LX Pool Heater / 400,000 BTU / Natural Gas
...is faulty. We have had nothing but problems with this unit since installed. Any idea on how to replace the switch? Thx check wiring if 120 volt you have to change wires to the ignitor its not ...
Question about Laars LX Pool Heater / 400,000 BTU / Natural Gas
jandy lx heater goes out on an gas fault. What will cause the igniter not to have voltage! The fuses found in the lead wires or next to where the lead wires connect to the ignition control board. Find
Question about Lx Pool & Spa Heater - Electronic Dual Ignition - Lonox - 400,000 Btu - Natural Gas - Lx400n
message says hi lim sw replace hi limits ther are 2 of them
Question about Lx Pool & Spa Heater - Electronic Dual Ignition - Lonox - 400,000 Btu - Natural Gas - Lx400n
...replace the ignitor in a Jandy lx400n-l, the manual does not show how to remove covers to get to the ignitor? thanks mike shut off power remove the burn rack pull out ignitor wire goes under rack ...
Question about Laars LX Pool Heater / 400,000 BTU / Natural Gas
how do you replace a pool heater pressure sensor? My heater won't ignite and gives a low pressure indicator. check pressure switch to see if voltage both sides if not see if copper tube is plugged
Question about Laars Lt 250,000 Btu Heater
...and the blower cools the system then the AGS Service error is displayed. I have cleaned my filters, replaced the blower, replaced the Hot Surface Ignitor, replaced the Flame Sensing Rod, and replaced ...
Question about Laars Lx 250,000 Btu Heater
I'm finding voltage at L2 and F2 but nothing at L1 and F1. Failure code is Air flow fault.blower running Replaced the ignition controller and the electronic controller check safety circuits
Question about Laars LX Pool Heater / 400,000 BTU / Natural Gas
...no lights of any kind light up. I have power at the ignition but not past that. Is there a reset or a fuse? Jandy Laars Lite2 Hot Surface Igniter Replacement Laars Lite2 LJ Heaters 2003 Present Pg ...
Usually answered in minutes!
1,045 Questions
774 Questions
337 Questions
287 Questions