Questions & Answers for: replace ignition cylinder 1999 olds

Question about 1999 Aurora

1 Answer

...ignition lock cylinder, it is not reading the key chip and locks u out, the problem is u can't just replace the lock cylinder u need a dealer only re-programm of the pass key system since the control ...

Ad

1999 olds aurora when you turn the key just says clean key wait 3 minutes the key has magnet on it that may be weakening. It will have to be reprogrammed. Insert the first valid key into the ignition ...

Ad

...olds aurora which when i go to start it, the security light comes on and dash light says " clean key wait 3 min " and car doesn't start try another key. if this doesnt work the wire in the tumbler ...

...ignition lock cylinder out.It has to be programmed to the vehicles ecm.Where do I connect the two wires attatched to the lock cylinder? follow the old wires and you should see where they plug in,the ...

the starter on a 1999 olds aurora... Where is the starter on a 1999 olds aurora Under the intake manifold. You need to remove the fuel rails and manifold to get to it. Not too difficult (about 2 hours

What is the procedure for replacing the power steering pump on a 1999 Olds Aurora? It has the northstar engine. Replacement dryer bearings for Coe, GrenzebachAKI, Gyptech, BSH, Metcar

1999 olds aurora wont run unless hold key in a certain position wont stay running unless you hold key in a certain position sounds like the ignition switch has an internal problem and requires ...

replace an ignition switch in a Oldsmobile Alero ... ? 14:05 https://www.youtube.com/watch?v=5FKwU467PKU Mar 10, 2012 - Uploaded by BuckeyeBryan How to replace an ignition switch in a Oldsmobile Alero

...1999 olds aurora. After stalling it starts back up. And doesn't usually happen again that day. Dirty throttle body, restricted injectors, bad engine coolant temperature sensor, weak ignition coil or ...

...replace ignition lock cylinder now nothing Someone tried to steal my Moms van. They weren't successful but they screwed up the ignition lock trying. I had to drill out old lock and after doing I am ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...