Questions & Answers for: replace hood release handle 2000

Question about 2000 Intrepid

2 Answers

...need hood open now. if not, stop at dealer a.s.a.p. and grab new handle assy, or autowreckers, and replace it before you destroy cable by using pliers etc.If cable actually broke, see above

Ad

...Hood release will not open hood with battery dead. There is a red release handle under the hood which I can apparently pull and hood should open. However this had been unsuccessful. Unless I am doing ...

Ad

...hood safety latch wont release If you pull on the release handle inside the car and it does not "pop" the hood open, make sure the hood is not already "popped". If it is, then try to push the hood ...

...release handle wont release brake if u nel down and look up in the middle u will see where the cable goes thru get a long screw driver and stick in where the cable goes thru and pull up as u try and ...

...hood latch not working correctly Does it look like the release cable might be stuck. Check to see if there is extra cable at the release mechanism inside the truck.You may need to replace the release ...

...HOOD RELEASE CABLE IS NOT ATTACHED TO THE HANDLE AND THE HOOD IS DOWN, WHAT SHOULD I DO. get some vice grips and clamp them onto the cable-have someone at the hood and when you pull have them pull up ...

hood release cable. Can't open hood broken hood release cable on my 2000 GMC Envoy Can't open hood , how do i open it? this is a hard one it depends on where it broke,can you cut the housing to get to

...replace a hood release cable for my 2000 Toyota Camry? unhook from latche ***. couple clamps down driver fender holding cable -rubber gorment thru fire wall -cable handle bolts under dash - put back ...

...then have someone push down on the hood while you pull the release handle. otherwise you will have to work from the front of the truck- it would be great if you had another truck to use as ...

2000 gmc Jimmy . I'm going to change the tie rods ,idle arm and the pitman arm . If there's any advice you can give me please help thanks. Locate the idler pulley to the left of the crankshaft

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...