Questions & Answers for: how to replace fuser thermistor

Ad

Question about Panafax UF-585 Plain Paper Laser Fax

1 Answer

...replace it the fuser thermistor makes contact with the heat roller. Normally they are in the middle of the roll. If you are experiencing a fuser error. Most likely the upper fuser will need to be ...

Ad

Question about DocuColor 12 Printer

2 Answers

...replace the fuser itself. Initial Actions Refer to BSD 10.2 and 10.12 for the following procedure. Perform the following: 1.Open the Drawer and extend it to the service position. 2.Remove the Oil ...

Ad

Question about T430 Laser Printer

1 Answer

...either disassembling the fuser and replacing the thermistor ( if you can find one) or replacing the fuser assembly. so i would suggest that take it to nearest service centre of lexmark. best of ...

Question about Infoprint 1572 Laser Printer

1 Answer

...replace the fuser top cover assembly. 3 Fuser to system board cable. System board Fuser assembly Reconnect the thermistor cable to J5 on the fuser board. Disconnect the fuser to system board cable ...

...replace the fuser thermistor. Fuser thermistor installed incorrectly. Check and reinstall if necessary. Fuser thermostat triggered. Check for continuity. If none, replace the fuser thermostat. Fuser ...

Question about FS-2000D Laser Printer

1 Answer

...482°F or more continuously for 3 s. Shorted fuser thermistor S. 1. Measure the resistance. If it is 0 Ï?, replace the fuser thermistor S. 2. Defective engine PWB. Replace the engine ...

Question about WorkCentre PRO 128 Copier

1 Answer

Replace the Fuser Unit Yes)Check the resistance of the Main Lamp between P600-3 and P600-7 for an open circuit or a short circuit . The resistance of the Main Lamp is 100 ohms or lower. No)Replace the

Question about KM-1815 All-In-One Laser Printer

1 Answer

...Replace the fuser heater 1 or 2. Installation defectiveness on fuser thermistor 1 or 2. Check the mounting state of the fuser thermistor 1. If any problem is found, repair it. Defective ...

Question about FS-2000D Laser Printer

3 Answers

...replace fuser then reset the code from the manual sadjnbdsvknsdlkvnsdv Decompressed, rotated, relocated, or blanked-out image data does not complete within a specified period of time.TURN THE MACHINE ...

Question about FS-2000D Laser Printer

1 Answer

Replace the fuser heater M or S. Installation defectiveness on fuser thermistor 1. -Check the mounting state of the fuser thermistor 1. If any problem is found, repair it. Defective fuser thermostat.

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Office Equipment & Supplies Experts

jasbo
jasbo

Level 3 Expert

2239 Answers

Marvin
Marvin

Level 3 Expert

85239 Answers

The Knight
The Knight

Level 3 Expert

76407 Answers

Are you an Office Equipment & Supplies Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...