...then press pedal and see if power going through switch to other terminal. If going in but not coming out, replace switch. Can use jumper wire between the 2 connectors to confirm brake lights come
no brake lights replaced fuse,bulbs. there is no power to the switch at the pedal blinker and tail lights come on. check hazard fuse or make sure the hazerd switch is dis engadged. mine was the same ...
...brake pedal is a brake light switch, there is a tab on the brake pedal that pushes it in when you let off the brake turning off the brake lights. replace this switch and your brake lights should ...
...light, remove the bulb, get a friend to push on the brake pedal while you check for power from the centre wire at the bottom of the bulb socket. If there is power there you will have a bad earth, ...
...brake lights at all. The tail lights are working fine. The fuses are all good as are the bulbs. Whats up? It is entirely possible that you have more than one issue.Perhaps you could fill me in as to ...
Question about 1985 Ramcharger
...the engine maintenance lights are on. how do i reset these lights?? The brake light has only two things that can make it light up one the emergency brake is on or two low fluid in the master
Question about 1986 Ramcharger
brake lights come on replace the switch. If not use a 12 volt test light to see if there is current to one of the wires. If not, check for a blown fuse. This should solve your problem. If not, contact
Usually answered in minutes!
56 Questions
39 Questions
30 Questions
11 Questions
117 Questions