Questions & Answers for: Canon how to replace a 2

...replace the fixing film unit. (2) Turn the power off and remove the fixing unit from the machine. Measure the resistance between the fixing unit connector J302-1 (FSRTH2) and J302-2 (GND). If the ...

...2 replacement inks(not canon) The printer worked satisfactory but subsequently I have replaced all inks with genuine canon. However it no longer prints and on screen reads replace printer head. Help! ...

Toner light stays on..printer doesn't want 2 print onlys says replace toners Toner light stays on..printer doesn't want 2 print onlys says replace toners replace the toners as indicated.

...2 batteries" are you including the date battery? See the "Replacing the Date Battery" section beginning on page 120 of this manual. you need to replace the internal battery which is located in the ...

...is executed every 100 msec after the start of motor rotation; however, the drive detection signal is absent for 2 sec. 1.Replace the Main Motor (M1). 2.Replace the DC Controller PCB

...2-way unit is faulty after detecting the connection with the finisher. Remedy 1.Install the 2-way unit. 2.Check the cable. 3.Replace the DC Controller PCB (PCB4). 4.Replace the 2-way unit driver

...2. Replace the DC Controller PCB (PCB4). 3. Replace the Cassette Pedestal Driver PCB. 4. Replace the 2-way unit driver PCB. 0010 When the communication with the 2-way unit is faulty after detecting ...

...between the fixing unit connectors J102-1 (ACH) and J102-2 (ACN), replace the fixing film unit. (4) Replace the ECNT board. (5) Replace the SCNT board

See Service Manual page 105

Check the condition of the gear at the host machine side (to see if there is something missing or swing with the gear) 4-2. Check the Cassette 1 Lifter Motor (M14) 5-2. Replace the DC Controller (UN09

...2 -> replace the sensor B-3. Faulty fixing belt unit -> replace the fixing belt unit B-4. Faulty fixing feed driver PCB -> replace teh fixing feed driver PCB B-5. Connection error of drawer ...