Questions & Answers for: removing starter from 2003 trailblazer

removing the starter though the same hole you are reaching though. Ps do not forget to disconect battery. make sure the bendex is in the correct position before you install or the wires will be a pain

starter or the alternator your park sensor may be messed up, try putting it in neutral and trying to start it then, and make sure you are applying the brake I've had the same problem. The first time I

starter has twelve volts to it contuniously. I followed the wiring diagram and descovered a diode conected to that wire and replaced it and no change. I cut the diode out of the wire and it solved it.

2003 trail blazer Any thing special to pay attention to? Will remove battery conection prior to removal of old one. Onceyou have the altenator removed, confirm that the diode pack is workin correctly.

starter on 2003 traikblazer Removal & Installation 4.2L Engine To Remove: Disconnect the negative battery cable from the battery. Disconnect the brake booster hoses from the engine. Starter Remove

Trailblazer will not start when steering wheel is tilted up. While holding key in start position and tilting the wheel down the engine will start. If left in that position it seems to start OK. If ...

2003 trailblazer. because it didnt work now iam trying to hook up oem starter wires under my dash but unable to vehicle ride for 2 secounds and dies By bypassing the factory ignition, you have cut out

2003 trailblazer wont start. I turn the key and get one click. The key turns and it clicks once. I checked the fuses and connections. The battery and alternator are both fairly new. We tried jumping ...

how do you remove the starter? Disconnect the Battery Cables, Remove the (2) Mounting bolts that go STRAIGHT UP into the Block on the Passenger Side of the vehicle. It will not come all the way down ...

2003 trailblazer will not start Truck has no crank- no start problems. Where do I start??? Check battery first, turn on lights to see if you have battery power, next check to see if the cable going ...