print head is full left and does not move. Does anyone know where I can order a replacement, and how to re-connect this strap in the printer? Go to the canon website, and into their tech solution area
...the seperate carts and removed any dry ink from the print head, but still wont print. I tried the hold form feed 4 times to see if that would work and it didnt. Change your cartridge and then try ...
print head on canon i9900 I have the new print head. Have removed ink tanks It is held in by a retaining lever on the top of the transport carriage. It is the lighter gray plastic piece on top. Follow
...print head and reseat them, if necessary. Check that the correct ink tanks are installed and that they are in correct order. Check to see if all the orange tape has been peeled off. If a part of the ...
print head. Remove all the inks then lift the grey lever to remove the black case that the inks go into. On the bottom of this you will notice the print head. Get some windex and a few sheets of paper
...to remove and reinstall the print head on my cannon i9900. Instructions from Canon support page: ...
...print head is what the cartridges sit in inside of the printer. For resolve the problem please follow these. Open the printer and wait for the carriage to slide over. Some how if its not come then ...
...print head will come to center. If you now look at bottom right side you will find 2 little sponges. They are the ink absorbers. Wipe them with a soft absorbent paper/towel till most of the ink is ...
...print head, where it reside when it is not printing. Again leave overnight and remove the next day. Try again and repeat above mentioned steps if required. Have patience. It may take several attempts ...
Usually answered in minutes!
2,817 Questions
2,244 Questions
2,162 Questions
2,149 Questions
1,912 Questions