Questions & Answers for: removing the motor cover Microwave Ovens

...motor cover comes as an unseparated part of the bottom cover and you have to use sidecuts or snips to cut away the little tabs which hold it in place. Then when you are done, you use a screw to hold ...

...cover and the motor and the shaft appears to be broken. How do I remove the broken shaft and replace the motor? Hi the shaft should just pull up, to remove the motor you will need to turn the oven ...

...or the motor drive/motor is faulty. remove the back cover and chek to get access, if motor voltage is not present check the program controller driver to the motor./ the trigger signal to the

...cover and remove the motor. Replace with the same type and the reverse procedure will fix it. You may however require a self tapping screw to affix the cover back on. A bit of a puzzle but not too ...

...cover and remove the motor. Replace with the same type and the reverse procedure will fix it. You may however require a self tapping screw to affix the cover back on. A bit of a puzzle but not too ...

...cover and remove the motor. Replace with the same type and the reverse procedure will fix it. You may however require a self tapping screw to affix the cover back on. A bit of a puzzle but not too ...

food cooks uneven with the fan running and has to be rotated to ensure even cooking Remove the mains plug , remove the glass plate and roller from the cabin , open the top covers and the rear covers ...

the drive belt or the turntable motor. Remove the bottom cover to confirm failure of the drive ,belt or if the motor has failed- check power to the motor when the microwave works if the motor tests OK

...motor. How do i get the cover off? I have removed all the Phillips head screws on the bottom, back and side. Do I have to remove the security Torx screws, too? You will have to remove anti tamper ...

...remove it. Replace it with the new motor. Replace the cover using a 3.. self tapping screw to secure it. Refit the turntable and dish, place a cup of cold water on the plate then plug it in and