Questions & Answers for: Chevrolet Blazer removing hose

how would i tell if the heater core is clogged? Under the hood there are two heater hoses going into the heater core,with engine good and warm,both heater hoses should be hot to touch,if only one is ...

where exactly is the thermostat located on 1999 chevy blazer 4.3 vortec follow your upper radiator hose to the motor. where it goes in is the thermostate housing, 2 bolts and it comes off follow Upper

My blazer does not blow any hot it does blow cold but also i'll put it on defrosters and it just continues to blow out of vents it wont switch out of vents.. any ideas? Check the blender door: Removal

...hose clamps that secure the hoses to the heater core. Then pull the hoses off the heater core.Removing the Heater Core Remove the heater core cover. Move to inside the passenger compartment. Locate ...

Would like a diagram of the heater core of a 1999 chevrolet blazer Remove the front dash panel by turning the lower screws in a counter-clockwise direction, then unscrewing the single bolt on the lip ...

...hose as the cause. It was suggested that the one way metal check valves ($15.00) that mount to the rt & lt exhaust manifold are worn and allow water from the exhaust to get sucked back into ...

changing the thermostat where is it? Locate the top radiator hose and follow it back toward the engine. Once you have reached the end of the hose, the thermostat is located in the housing the hose ...

...hose that runs to your Recovery Resevoir. #7) Now you'll need to remove the 2-Side (PLASTIC) Panels that are part of Shroud. #8) If nessessary now Remove the Retaining Bolts that hold the Radiator to ...

small steel coil in the front of the radiator has a pin hole leak and is causing a loss of power steering on a 2002 chevy blazer s10 ls 4x4 remove your air filter housing - remove 10mm nut on back ...

need new thermostat thermostat location Follow the radiator hose that goes to the top part of the engine. Where the hose meets the top of engine, that the Thermostat. Remove the radiator hose, then ...