Questions & Answers for: Jeep Wrangler removing head

How to remove the top bolts from the rear shocks Not prblem on the bottom bolt but How do you remove the top bolts from the rear OEM shocks? Are the fittings welded to the body or are there nuts ...

1989 jeep wrangler has been stored for 2 years The jeep belonged to my daughter and her not very mecchanicaly minded husbund was sure it had blown up. I can get it to run if I pump the gas pedal ...

how do i remove the switch from the dash brackets use a flat head screw driver and pry out the face plate first, and be sure you have removed all necessary screws first.

where are the spark plugs for 2006 jeep wrangler in the cylinder head under the ignition coils that are over each plug, remove the coil to access the spark plug (one coil for each plug)..

steering tilt dose not stay tight if you remove the covers off the column, you will see 2 screws towards the back on the sides of the column, inverted hex head. it is comon for these to work loose and

...removing cylinder head. I have tried prying on it with a "wonder bar" also a crow bar. Any suggestions for getting it lose from the block? It is a 1998 jeep wrangler 2.5l There is a notch where you ...

...head Fig. 10: Removing the cylinder head from the engine block Remove the head bolts. Lift the head off the engine and place it on a clean workbench. Remove the head gasket. To install: Thoroughly ...

need to know lbs of torque and sequence for the heads on a 1995 jeep wrangler with a 2.5 From autozone.com: To install: Thoroughly clean the gasket mating surfaces. Remove all traces of old gasket ...

Do I need a special wrench to remove the radiator bracket on a 2001 Jeep Wrangler? You may have torx head screws there, like on a '95 cherokee: size t-30 for the radiator bracket,  and oddly ...

How to remove rear headrests from Wrangler unlimited How do you remove and replace rear head rests THERE IS A RELEASE BUTTON THAT YOU HAVE TO HOLD IN THEN JUST LIFT UP ON THE HEADREST