...agitator in bottom center of tub must be removed (short screw driver should unclip it at four small holes) #6-remove 6 bolts from around inside of area that was under cap and remove plastic washtub ...
...agitator plastic pan but Im thinking there has got to be an easier way. Is there? The pan goes up and down like it is supposed to during the wash cycle. Remove the center plastic cover with a little ...
...center, thus reducing the shock hazard. 4. Before turning the machine on, remove a cover. On some washers, there are two screws on the bottom L & R front corners that take the front panel loose. ...
Question about Calypso GVW9959K Top Load Washer
...center, thus reducing the shock hazard. 4. Before turning the machine on, remove a cover. On some washers, there are two screws on the bottom L & R front corners that take the front panel loose. ...
Question about Calypso GVW9959K Top Load Washer
...agitator center cap that grip the agitator and turn it during the wash cycle. They can (and do) wear out dependent upon the use of the washer. If you are in the habit of doing large load sizes ...
Question about Calypso GVW9959K Top Load Washer
agitator and removing the retaining biolt then lifting out the agitator. Use a putty knife and scrape off the inside of the wash tub under the agitator. Also take the agitator either outside or to the
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions