Questions & Answers for: remove windshield wiper arms 1997

Question about 2002 Grand Prix

2 Answers

...windshield on the driver's side of the vehicle. It is not too hard to get at and you will need to remove at least the lh wiper arm. It is very possible it is a linkage problem and not the motor (the ...

Ad

windshield wipers won't work when i turn the wipers on they come up about 2 inches and then they lower back down into the off position. Is there a little motor for the wipers that may have died? or is

Ad

windshield wipers came apart at the base (under cowling) got it fixed they work now but the driverside stops at 3/4 swipe then goes down. passanger side fine, how can we re-ajust the driver side to do

...wiper going past windshield and now is not in sync with other wiper arm,and still moves past windshield and jams up. The arm is stripped onto the stud its pressed into which is call a wiper ...

...windshield wiper kind of "runs it over". How do I fix that? The wiper arms are mounted to "splined" shafts. Either the arm or shaft may be stripped. You need to remove the arm and inspect

...windshield wipers are out of time, stop in straight up hi you can try, removing both wiper arms then turning wipers on ( without arms connected ) then turn them off, once set as normal refit the the ...

Question about 2002 Grand Prix

1 Answer

...Windshield wiper problem passenger side wiper acts erractically I assume that the drivers side is working perfectly and only the passanger side has a shorteded erattic sweep . It will be either a ...

windshield wiper one stop moving on my 97 grand prix Hello, you'll will need to remove wiper motor crouling to get the wiper motor. There will be two rods attached to the wiper motor. Now, this ...

Question about 1999 Grand Prix

1 Answer

...know where it is located IT IS LOCATED INSIDE THE WINDSHIELD COWL. DIRECTLY BELOW YOUR WINDSHIELD UNDERNEATH THE THAT PLASTIC THAT LOOKS LIKE A NET. U HAVE TO REMOVE WIPER ARMS BEFORE REMOVING ...

...remove the actual windshield wiper arm? I've gotten the cover and bolt off, just can't get the arm loose from the post. Sometimes you have to use a small gear puller. The arm could be ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...