remove the wash plate and untangle the robe. Does it take a special tool? Thanks. The wash plate (or nunater) can be removed by following these instructions. It may seem like a lot, but the wash plate
...remove wash plate. I had three pieces of laundry underneath, 2 socks, & a microfiber runner's tank top. I concluded this to be the major problem caused by the small items entering in the gap in ...
Question about Calypso GVW9959K Top Load Washer
...remove either the outer or inner wash plate or you have compromised the water tight seal for the U-Joint which drives the wash plate, and the washer will eventually fail completely (rust out the ...
Question about Calypso GVW9959K Top Load Washer
...AND how do we get "stuff" out from under the washer plate? Remove the front panel and the hoses will be accessible. Removing the wash plate is not advised unless you are prepared to replace seals. ...
Question about Calypso GVW9959K Top Load Washer
...wash plate on a Calypso is called the "nunater". The following link explains step-by-step how to remove it: http://www.fixya.com/support/r1065026-calypso_nunater_removal It is common for clothing to ...
Question about Calypso GVW9959K Top Load Washer
...remove a small pice a ziper from underneath the main wash plate ? Kenmore elite calypso washer 110240842000 Have you tried a shop vac with a nylon over the end of the suction pipe yet ? Usually works ...
...enough just pop the center cone up and out by depressing three screwdiver slots around seam. Then some 3/8" bolts secure wash plate. You are suposed to replace some orings every time you remove
Question about Calypso GVW9959K Top Load Washer
...Remove the wash plate center dome from the wash plate. This is the center cone on top of the wash plate. Use a flat blade screwdriver and insert it into any of the slots available along the sides. ...
...the agitator Pry center cap from plate, you will then have access to several 3/8" screws. Once removed, the plate will pull out. You must remove tub ring if you want to totally remove it from the
...plate Remove the agitator dome by pressing on the 4 snap ins on the bottom of the dome and wash-plate. Remove the bolts from the wash-plate and lift it out. Here is a exploded diagram of the
Usually answered in minutes!
9,125 Questions
3,839 Questions
3,158 Questions
2,979 Questions
2,660 Questions