...remove the Video 3 and other lables from the top left of my tv screen? It is normal for VIDEO 3 to be displayed in the upper left of the picture if there is no signal present at the INPUT 3 jacks. ...
...Video 1, 2, 3, 4 and Initial Sony Setup Screen. I've unplugged cable box and TV and plugged back in. Changed batteries in remote. No doubt ... try to check out the memory module and the T board...... ...
...remove back to undo 2 more screws inside TV. The screen/focus Block is behind it 3 controls on top 3 on bottom R-G-B Check Video IC on CRT board of Red Tube/ First try adjusting Red screen drive ...
...Especially if it's HDMI, they come out EASILY. Make sure TV is working properly with other things, it could be your TV. If all cables are correct remove the game and whatnot and try different
Question about KP-57WS520 57" Rear Projection HDTV-Ready Television
video input channel stays on screen in upper left hand corner of my sony 57in hdtv rear projection WITH AN ORIGINAL SONY REMOTE HIT THE DISPLAY BUTTON TO REMOVE THE INPUT ON SCREEN DISPLAY---IF YOU ...
...video reset an to enter safe mode, no difference besides e TV sensing a lower resolution. Any idea? Thanks. Try booting the PS3 with the hard drive removed from the drive bay ( on the side) you just ...
...video" stays on the upper right corner of the screen. when I raise of lower the volume both dissapear but reappear as soon as I'm done adjusting the volume. How can I get these images off my ...
Question about FD Trinitron WEGA KV-32FS120 32" TV
...top and bottom of screen. Can't remove. either you have the video setting of the television set to wide screen or you are purchasing "WIDE SCREEN" format dvds instead of "FULL SCREEN" format ...
Question about FD Trinitron WEGA KV-34HS420 34" TV
...3 aspect ratio located, I would like to remove it from the old 40" motherboard/chassis and install it in 34" motherboard/chassis. There are many boards in the motherboard/chassiss of any ...
Question about FD Trinitron WEGA KV-34HS420 34" TV
remove it. VIDEO blinks off a fraction of a second and comes back. Have two identical TVs with same behavior. Display button works on remote since it does remove the channel/main text while on TV mode
Usually answered in minutes!
2,410 Questions
2,254 Questions
1,646 Questions
1,423 Questions
1,438 Questions