Questions & Answers for: remove rotor button 4 3

Question about OLY-OL3000 Globe Phone

4 Answers

...remove the three screws that hold the rotor (looks like an "L") to the motor shaft. The LED display is soldered to the rotor. These solder joints break and need to be re-soldered. By adding a small ...

Ad

Question about 23 in. DD-603SS Built-in Dishwasher

2 Answers

Remove the rotor and use a cable tie or wire tie to push through the hole closest to you at the bottom of where the rotor sits. If you cannot find the hole, remove the rotor from the bottom drawer (if

Ad

...remove the cap and watch the rotor button as it turns, have someone crank the engine to see, looking for which direction. Next turn the engine by hand looking for any marks on the crankshaft pully. ...

Question about 1984 Sportvan G30

2 Answers

...rotor button and the distributor contacts. Have you tried changing the rotor button and cap. Is the van hard to start after driving it, or initial start of the day. If it's one of these, then the ...

...rotor turns, you'll have to remove the distributor cap and have someone crank the engine over to see which way it turns. Now, if you have ALL your wires from the distributor cap removed, you'll have ...

Question about 1993 Sentra 4 Door

1 Answer

...rotor button, this would not cause the timing to be off. As long as you don't remove the distributor a and turn the engine over. If your car is running rough it could be the wires were put on wrong, ...

If I had difficulty removing the old rotor button and turned it trying to remove, would it throw off the timing? no, they have a flat on one side an a bolt on the other. its not possible

...rotor does not solve the problem then the ignition module or the pick-up coil/stator assembly inside of the distributor is also most likely damaged and the distributor will need to be replaced. There ...

...remove the one going to #4 cylinder and see if spark jumps to chassis through the side wall of boot. If so, replace the wire. It also could be the #4 post on your distributor. It's part of the cap ...

...remove the rocker cover and plugs turn the engine over untill no 1 cylinder valves have clearance under the rockers put the ht lead in the cap that faces the rotor button turn engine over until you ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Lands Phones Experts

Cindy Wells

Level 3 Expert

6688 Answers

k24674

Level 3 Expert

8093 Answers

Brad Brown

Level 3 Expert

19187 Answers

Are you a Lands Phones Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...