Questions & Answers for: remove protect kenwood

...fixed the speaker wire problem but I couldn't get the "protect" message to reset. I had to remove the unit from the dash and unplug the power supply. I plug it right back in and it was back to

...remove the Protect mode. THX Turn on the car so the radio is flashing "Protect."  Look on the front / removable face of the stereo.  On it you will find a small round hole - that's a ...

protect", then you'll definitely have to remove the stereo and do some troubleshooting to fix it. Many car audio stores will do system troubleshooting, for a fee. If you want to do it yourself, here's

...remove protect mode on my kenwood kdc-x591 find the lil hole in front of the face use a paper clip to reset it if it keeps on doing it you got a speaker going bad I have reset my kanwood system and ...

...protect keeps flashing on my kenwood kdc-w3037 how can i remove it make sure you have no bare or shorted speaker wires and check your speakers to make sure they are all good. if that all checks out, ...

...kenwood model kdc-mp538u not turn on just says remove circuit protection and audio and says the same protection you have an answer to this Please traslate this; quita el modulo de radiofrecuencia ...

...protect mode. Solution: Open the hood of your car or van, and disconect 1 battery wire, do-not let the battery wires touch, this will re-set the stereo back to normal, you do not have to remove the ...

MY kenwood KDC-W3044 is showing protect on the screen....... what should i do to remove?????? MY kenwood KDC-W3044 is showing protect on the screen....... what should i do to remove??????

protect and i can't remove it. can you help please? A speaker wire has a short-circuit, crossed, or touches the chassis of the vehicle it activates the protection mode function. ? Wire or insulate the

...PROTECT ON THE SCREEN AND DOESNT PLAY Check your speakers and speaker wires for and shorts and/or grounds.  If they all check good try resetting the radio.  If there is a reset switch, it ...