...remove the white carrier to replace the pin? Or what is it called (and where do I shop) to replace this white carrier? its a cartridge chip reader, you can remove the plastic peace with 3 pins, first ...
...remove pc drum and all toners, under the toner rack there is a 3 pin chip reader, use pressure air to clean it. if the new BK toner is not original, it will say only not genuine toner but will print. ...
...remove backside and left side cover, in backside there is a 4 small wires with 2 pin connectors you have to unplug connector, in left side there is a bigger withe and black wires, you have to unplug ...
...remove all toners, clean toner chips with alcohol. then locate a 3 pin reading chip under the toner rack left side and use pressure air to clean it. reinstall everything. if its not helping, replace ...
...here are many problem like this, this is a common problem for MC 24xx/25XX series. you have to remove pc drum, and all toners, find small black plastic switch on right side from toners push it ...
Question about Magicolor 2530 DL Laser Printer
...pin is, closing the switch, to fool the printer into thinking that the cover is closed. You can try this by pushing a pen point into the hole to see if the message goes out. (Don't forget to remove ...
Question about magicolor 2400 Laser Printer
replace a new 3 pin contact but I don't know if konica stocks this item. Temp. fix can be done by bending each pin a little bit outward, but you have to remove this assy outside from the machine first
...turned machine off, removed power supply, etc. Any ideas? Clean toner chip reader, remove OPC drum and all toners, under the toner rack there is a 3 pin chip reader, use pressure air to clean
...now says others not installed and "cannot rotate cartridges" Clean toner chip reader, remove OPC drum and all toners, under the toner rack there is a 3 pin chip reader, use pressure air to clean
...a pin or stappler might be stuck there just remove it. your printer will work fine. Secondly check that if any plastic is burnt or melt over there if so then use something rough to make it
Usually answered in minutes!
321 Questions
259 Questions
244 Questions
182 Questions
115 Questions