Questions & Answers for: remove picture tube old tv

remove the Neck PCB gently from the Picture tube, and (very carefully, mind you!) clean the Picture tube Contact Pins. Again, very slowly and gently, replace the PCB. Try your TV again. Let me know if

...picture tube could be weak. IF not then there is a screen adjustment on the flyback transformer that you might try to adjust. Sometimes you can access this adjustment without removing the back cover. ...

picture tube? no, not at all. it might be due to change in direction or some body might have turned tv direction or any magnetic thing might be near tv.remove it like speaker or headphone etc. put off

...remove the old Tube and install the new one. Your model has picture tubes instead of lamps. Leave them an email with your model number and which CRT (picture Tube) youre needing they respond quickly. ...

picture tube connection. remove all wire connections and attempt. If problem repeats, Refer to a schematic diagarm for spark arresting components. Generally mounted on the picture tube pin base PCB on

...picture tube technology type try the following. The following is for technical experts only It is EHT cable contact problem. Switch off TV. Remove all electrical wire connections including antenna ...

...picture tube is defective and confirmed it is a serious fault. You can rejenuvate the picture tube with a gun tester and short remover.This is not a confirmed solution but you can take a last try. ...

...remove any loose contact between bascard socket and picture tube pins. If this doesn't hlep, desolder it out from the picture tube base card, go for a similar type and pin confuguation. Replacing it ...

my tv turns on but no picture just turns on is this ur old picture tube tv?if it is so then it must be due to accumulation of moisture in the tube which can be eaisly removed by any mechanic.

...picture tubes with screens like the old tv sets===the coating has been burnt in each, want to prove it, remove rear cover and cover any one of the three lens and that mark on one tube will go a way. ...