replace batteries on phillishave HQ7780 Batteries will not hold charge & need replacing. I do not know what type of screw driver is needed to remove the shavers screws You neet torx T9 , quite cheap.
Question about Philishave Cool Skin HQ6760/HQ 6761
...philishave cool skin on charge about 9. a.m. went to use it at 5 p.m. same day - light had gone off so fully charged but wouldn't work and still can't get it tow work. Have I overcharged? I copied ...
Question about Philishave HQ7780 Electric Shaver
...when i put the head back on it sounds like one of the heads is dmaged causing them to lock up. remove the one at a time and turn on in between removing the next one to find out if one is
Question about Philishave HQ6849 Electric Shaver
...philishave hq 6849 which is about 5 years old. I charged it yesterday and today it is "dead" when I plug it in the mains the greenlight comes on but nothing else happens. Is there an internal battery ...
Question about Philishave Cool Skin HQ6740 Electric Shaver
...Philishave Coolskin to accept a charge. Pretty sure that the charger is working as I was getting the red charge light but didn't get the green bar indicators as it charged. Any ideas Most likely, the ...
Question about Philishave HQ7740 Electric Shaver
...philishave no longer seems to hold a charge.Is it possible to replace the battery? Yes, there is a battery pack inside that can be changed. You will find replacement batteries for model HQ7740 at ...
Question about Philishave HQ7780 Electric Shaver
...batteries rather than unsoldering them from the circuit board. This allows the old batteries to be removed but leaves the tabs attached to the circuit board. You can then solder the tabs from the
...philishave HP1335. I connected it to the mains for charging. It showed it was charging as the green light blinked. But after 2 minutes none of the lights blinked, neither red nor green. What's that ...
Question about Philishave HQ8894 Electric Shaver
...batteries rather than unsoldering them from the circuit board. This allows the old batteries to be removed but leaves the tabs attached to the circuit board. You can then solder the tabs from the
When you remove the 5 screws,how do I get the back off so that I can replace the battery? The cover will come off once the screws are removed but it is sealed fairly tightly. You will need to gently ...
Usually answered in minutes!
356 Questions
246 Questions
187 Questions
140 Questions
159 Questions