may not change .. check the cold water temp. sensor and the electronic egr valve. if it is the egr, remove it and clean it, replace it and you may need to buy a new gasket for it. it will work as good
...THE THROTTLE BODY AT FRESH AIR RETURN HOSE FROM THE AIR FILTER CASING. HAS TWO WIRES AND ONE SCREW. REMOVE SCREW PULL OUT IAC AND SPRAY WITH CARB CLEANER THAT DOES NOT LEAVE RESIDO. MAKE SURE THE O ...
be a short in the harness to the MAP sensor. Turn the ignition off. At the PCM unplug connector and remove the MAP signal wire from the connector. Re-attach the PCM connector and see if with KOEO, the
Blinking Check Engine Light / Rough Idle Recently i tore down the top end of my 2.2 to replace the head gasket and all the gaskets the rest of the way up. After reassembling the engine its running ...
Blinking Check Engine Light / Misfire / Rough Idle Recently i tore down the top end of my 2.2 to replace the head gasket and all the gaskets the rest of the way up. After reassembling the engine its ...
be a short in the harness to the MAP sensor. Turn the ignition off. At the PCM unplug connector and remove the MAP signal wire from the connector. Re-attach the PCM connector and see if with KOEO, the
Question about 2000 Sunfire
...locations etc Many public libraries have manuals or subscribe to on line services such as Alldata. Remove the throttle body. Disconnect the MAP sensor electrical connector. Remove the MAP sensor (1) ...
Usually answered in minutes!
987 Questions
731 Questions
699 Questions
696 Questions
696 Questions