...sensor connector. Repair any damage 2. Unplug the MAP sensor connector. Also, at the PCM connector, remove the MAP sensor signal wire and check for continuity to the MAP sensor connector. If there is ...
...WIRING HARNESS FROM THE MAP SENSOR ( LOCATED ON THE TOP OF THE ENGINE ON THE INTAKE MANIFOLD,) REMOVE U SHAPED RETAINER IT HOLDS THE SENSOR DOWN ON THE MANIFOLD YOU MAY NEED TO REPLACE THE SEAL ...
WHAT IS REDUCE ENGINE POWER AND WHAT MAKES THIS HAPPEN? ENGINE POWER SUDDLEY REDUCED AND NOW VEHICLE WILL ONLY GO 20 MPH. The onboard computer, or Powertrain Control Module (PCM),is the brains of the ...
...along with the hoses that connect to the throttle body. Take the 4 bolts off the throttle body and remove it. No need to worry about a gasket, just has a rubber O ring that is re-useable. Clean with ...
...XtremeThrottle Position Sensor (TPS)REMOVAL & INSTALLATION PrintRemoval & InstallationRemove the idle air control (IAC) electrical connector (1) from the IAC sensor (4).
Question about 2008 Envoy
...easy, If the catalytic is to difficult to disconnect, plus you need to secure from falling remove the 02 sensor on each bank before the catalytic,this may be a easy approach.Just to let you ...
Usually answered in minutes!
2,225 Questions
1,368 Questions
1,418 Questions
593 Questions
540 Questions