Questions & Answers for: Ford F-150 remove maf

...This, if damaged, should cause a CEL ( lean indicators ). Last while you have the MAFS cleaner, remove the IAC ( Idle Air Controller ) on the back of the throttle body and clean it. This can

idle sensor or possibly an o2 sensor If it is a 5.4L V-8, pull the plastic throttle body cover, and remove the IAC ( Idle Air Controller ) on the back of the throttle body. You can use MAFS ( Mass Air

i have a 2001 ford f150 5.4 v8 the rpms jump around from 400 to 800 when i start up and let it idle. I took the air intake off completely and started it back up and it ran fine. would the sensors be ...

...is not MAFS safe. The next is to check the rubber elbow on the back of the throttle body ( need to remove the plastic throttle body cover to see this ) and the vacuum line to it. Usually the rubber ...

MAF sensor cleaner.Dirt sometimes accumulate on the sensor and that could cause for poor mileage.Before changing your engine oil clean fuel injectors and sludge from the engine using 3 oz pure acetone

line elbow on the back of the intake as well. The IAC is on the back of the throttle body ( need to remove the plastic throttle body cover to see it ). The rubber elbow is just above it ( line running

...MAF.. Carefully remove the clamps holding the hoses to it, spray it liberally with MAF cleaner. Keep the nozzle of the spray at least 1 to 2 inches away (There are some very fine fine fine wires in ...

...listed could be a few things, but the list looks to be the cracked rubber elbow. You might need to remove it to check for cracks ( or it is some where around 20.00 from Ford ). This is a picture of ...

remove 401 error code now the engine idles faster and 171 and 174 codes are showing up any ideas thanks g. 171/174 too much oxygen in the exhaust, sounds like you may have a vacuum leak after the Mass

...at NAPA ( CHA 7989 ) Replace front ( 2) O2 Sensors at 100,000 miles Clean MAF Sensor---CRC MAF Cleaner Check TPS Sensor -- It is replacable-you can do it Need a hair dryer to remove screws 2-T20 ...