...key on then it lays there as you crank. Since it ran good, then wont start... I bet you'll get an igntion module wrench, take off the TFI on the side of the Distributor (dont bother dist setting ...
...remove I lost the key for my truck (don't ask, it's stupid) I can't turn the tumbler to the "run" position to remove the assembly. I drilled out the pin but the switch won't pull out. I believe it's ...
...remove I lost the key for my truck (don't ask, it's stupid) I can't turn the tumbler to the "run" position to remove the assembly. I drilled out the pin but the switch won't pull out. I believe it's ...
key hole now how do i get the switch out to replace? take a drill and drill out the tumblers use small bits to start off and then use large bits to finish out the job when the tumblers fall out take a
...remove and replace an Ignition switch in a 1985 Ford F 250 V8 Diesel? can't remeber if i told u how, there is a small access hole under the lock tumbler in the column trim... with the key inserted in ...
...assume you still have keys and can turn to the run position to eject the old cylinder. So how can I remove the old lock cylinder without the keys? You can grab the switch with pliers sometimes and ...
...key and tumbler, you have to pull the steering wheel, remove the screws from the signal cam, and then remove the locking bolt that holds the tumbler. You will need a steering wheel puller to remove ...
Usually answered in minutes!
907 Questions
705 Questions
546 Questions
442 Questions
465 Questions