Questions & Answers for: remove hud

...remove center nut In the center of the hud, there is a steel cover. use a screw driver and a hammer to tap the cover off. Make sure you take the handbrake off, and undo the center nut and take the ...

Ad

Question about 2004 Grand Prix

2 Answers

HUD will not light up I replaced the 10 amp fuse inside fuse box in regards to HUD/DIC controls. I also replaced the fuse outside in regards to the over all display feature. checked control panel ...

Ad

...mirror assembly comes unhooked or pulls through the plastic anchor hole. The HUD unit needs to be removed out of the dash for repair. Several people have epoxied a washer where the original hole

2006 Suzuki SV 650 will not turn over Bike's headlight and HUD light up but when I press the ignition button nothing happens.Already checked the fuses and they are fine. HUD has an indicator that ...

...HUD switches Disconnect the negative battery cable. Remove the steering column opening filler panel. Remove the instrument cluster, as outlined earlier in this section. Depress the locking tabs, then ...

...HUD. If this is the case, you are in luck. Remove the A-pillar moldings by simply pulling them off. You must then pull up on the plastic dash molding that encases th HUD and runs the entire width of ...

Question about 1993 Econoline

1 Answer

...remove rear drums Yes We can. Once the wheel is removed you will have to get a large hammer and give it a few good wacks. If this does not do it, get a can of liquid wrench and spray it down paying ...

Question about 1992 Explorer

1 Answer

...to do. what size socket do i need to remove this nut in order to remove hud that i may be able to see bearings. You need a shop manual and the proper tool borrowed or bought from Auto-Zone. ...

Question about 1992 Explorer

1 Answer

...and replace list key take ruber boot off ignition unscrew nut a little unhook wire hud under dash remove nut take out or the other type uses prongs to hold in sqeeze prongs and push out switch ...

...remove the drum or brake disc use a tool like a ball joint remover clamp to push the broken stud out of the hub fit the new hud stud and pull it into place of course it is more professional and ...

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29492 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...