Questions & Answers for: GMC Yukon Denali remove head

remove the bottom outboard bolt, accessed by partially removing the inner fender. My head light is broken and I need to replace the whole assmbly. How do I do this? I found this on a chevy truck forum

...head light on the passanger side. I have a 2007 cevy Tahoe. How do I replace it. the bolts hold the headlight bazel on are located on the inside of the engine compartment. if it's on the side where ...

...head light on my 2008yukon denali with out pulling air filter box out and windshild washer out This is a rather difficult task to perform as the complete headlamp must be removed to do so. Here is ...

...head lining above in the center ) remove the panel for the switch and there might be a relay in there, alternatively you should be able to manually close it, this should be in the same place.....hope ...

...remove and repair the head gasket. You may also find water in the engine oil or water in the cylinders which can cause locking of the engine and serious internal damage if not addressed immediately. ...

...head light does not work...the high beam does Change the bulb. High and low beams are separate bulbs located in the headlight housing. Im not sure on the 07 but the earlier design Yukon (02)you have ...

remove and replace blown license plate bulb 2006 gmc yukon ensure the head lamp is in off posiition..remove the lens from the bulb assy,and remove the bulb and replace.

...head. Remove the generator. Remove the oil indicator tube bracket bolt. Remove the generator mounting bracket. Remove the sixteen cylinder head bolts. Remove cylinder heads and gaskets. Clean all ...

...pink acid that gm calls coolant??you stated the head gaskets are great ,you can only tell if you removed the heads...............and the fluctuating temp guage says head gasket also ,get your ...

...head removal or anything remotely close to TDC. That won't apply to this project. You'll have to remove the front wheels & inner fenders which are plastic. This allows easy access to the exhaust ...