...roller brush. I didn't pay attention when I removed it and now when I attempt to vacuum my low carpet it doesn't seem to be working. The green light on the head of the vacuum goes out when I click it ...
...Remove the plate and the roller will come out. Be sure to notice that the roller has a magnet at one end that lines up with the indicator that shows you when the roller is turning - it's the little ...
...Kirby Classic 1972 1. turn to off position, remove head 2. remove roller and old belt 3. replace new belt 4.replace roller on head, turn to on position 5. turn on vacuum, roller still doesn't turn, ...
remove the end caps (one at a time) and clean the hair out from the bearings underneath the cap (in the shop I use WD-40 and a non-serated pairing-knife). Replace caps they only go one way. If you can
Question about Ultimate G Bagged Upright Vacuum
...Remove this end of the roller. If you need to replace the roller take it all the way out. Remove any carpet fiber, string, or hair from the roller with a scissor. Step 5: After you have removed the ...
...Remove the bottom cover and inspect the brush roller for damage--breakage of the roller, bad or broken end bearings, missing brush sections, or something stuck to the roller like a wad of gum or ...
Question about Ultimate G Bagged Upright Vacuum
end of the tube. Ways to increase your Ultimate G cleaning efficiency. Take off the vacuum head and remove the brush roller. Attach your hose attachment and **** vacuum out the head. Put on a new belt
Question about Generation 3 Bagged Upright Vacuum
...remove the roller brush assembly (clean and lightly oil {3-1 or similar} the end bearings), then slide the new belt over the brush and locate the belt on the lifter device that places the belt over ...
Question about Heritage II Vacuum
...sets behind the roller brush inside of the casing The brushroll is held onto that baseplate by the metal brackets on either end of it. You have to slightly bend them outward to remove the
Question about Heritage II Vacuum
...WILL NOT TURN---i HaVE REPLACED THE BELT AND CLEANED ASSEMBLY---I HAVE KIRBY SENTRA There may be dirt, hair, etc. lodged inside the end caps. Remove the brush roller and remove the end caps to
Usually answered in minutes!
1,132 Questions
1,137 Questions
870 Questions
836 Questions