Questions & Answers for: Chevrolet Cavalier remove cover

...need to remove the cover (it prises off with some persuasion) and then you'll see the remaining bolds. With the black cover removed you'll also be able to see the bulb holder/socket. Hope this

cover bolts. 9.Remove the water pump retianer nuts. Remove the old gasket and clean. 10.On bench. Install the waterpump and cover but lreave the bolts finger tight. 11.Install back in car, leave water

...Remove or disconnect the following: Oil pan. Crankshaft pulley and hub. Timing cover bolts. Timing cover. If necessary, tap with a rubber mallet to loosen the cover. Clean the mating surfaces. To ...

Remove timing cover(helps to remove two bottom studs on cover that pass threw oil pan use the two nuts on them as jam nuts on the studs). Put #1 cyl. t.d.c with crank. timing mark pointing @ center of

...Remove the Top Engine cover to give you better access to the Front of Engine. #3) Then you'll need to remove your alternator and with wiring attached put it off to the Side you might have to tie it ...

of car on engine then remove that cover. To make removal easier take off air filter inlet tube and move the wires close to cover. The filter snaps into cover so you should be able to pull it right off

...remove the cover of the 1991 cavalier 2.2 engine. i remove the wingnuts but the cover does not come off. i check the manual with no resolution. Welcome to Fixya. First, make certain that there are no ...

...Remove the crankshaft pulley. Unfasten the front cover-to-block bolts and then remove the front cover. If the front cover is difficult to remove, use a plastic mallet to carefully loosen the

cover bolts. Remove the manifold to exhaust pipe bolts from the exhaust pipe flange as follows: Unscrew either bolt clockwise 4 turns. Remove the other bolt. Remove the first bolt. On the 2.4L engines

...remove the ignation coil pack cover you will see to very thin covers this are not valve covers they are camshaft covers and if you unbolt them you will be removing the camshaft towers and this is not ...