Questions & Answers for: Hyundai Accent how to remove clock

2002 1.6 litre, remove crank pulley bolt for timing belt replacement. clock wise or counter clock wise to remove bolt. counter clockwise

...remove the panel from boot lid (clips+screws) then you will see rear of n/plate lights the bulb holders twist anti clock slightly and pull out replace bulbs with same type 5watt check all work b4 ...

...clock in place. Thanks ! You'll need to remove the entire vertical console (pops out after you remove two phillips screws at the bottom behind the cup holders). There are two phillips head screws ...

need to remove dashboard instrument panel to replace bulbs on a 2000 w reg hyundi accent there are screws in the black plastic trim around the clocks, remove these and pull the trim forward. then ...

...clock has blown Going with the premis that the radio is correctly connected,you blew a fuse.Locate the fuse panel by your left knee and remove the cover.Should be a fuse legend on the inside of the ...

...Remove the negative battery cable from the battery. Using a 12-volt test light, hook one end to the negative battery post the other end to the negative battery cable you just disconnected. The test ...

...clock position. A dot can be seen through the hole in the camshaft sprocket when it is vertical and lined up perfectly. 4) Loosen the two bolts in the timing belt tensioner and pry the tensioner away ...

...CLOCK RADIO. IF YYOU DONT HAVE A WORK SHOP MANUAL TO RETREIVE WIRING DIAGRAM AND SOMEONE THAT CAN READ THE CCT THEN YOUR OUT OF LUCK.TAKE IT TO YOUR AUTO SPARK IT WILL BE CHEAPER THAN DEALER. YOU CAN ...

...remove the clock and have it repaired or replaced depending on what is cheaper. I agree with Dennis, if you are pushing the buttons and the time still isn't changing, it might be time to get it ...

...Accent Problem: intermittent starter problems_starter does not turn the motor over Starter was removed, rebuilt, removed again, checked and reinstalled. Still has intermittant starter problems ...