...clipper/trimmer blades must be oiled both before and after use. Hold the unit with the blades pointed toward the floor. Put a dab of oil across the front of the blades and turn the unit on to get the ...
Question about Golden A5 2-Speed Universal Motor Clipper 78005-140
Remove: IMPORTANT- stop motor; push latch with thumb while lifting blade away from clipper and slide off tongue. To Replace: turn motor on; insert blade on tongue fully and then snap blade into place.
Question about Golden A5 1-Speed Universal Motor Clipper 78005-010
Remove the bakelite gear (the part that the link fits down over). You should then be able to see if the teeth are chewed or worn off to the point that the armature gear will not turn the bakelite gear
Question about Golden A5 2-Speed Universal Motor Clipper 78005-140
remove the clipper blade on the front of the clipper their is a lever color red grab this part with your 2 fingers and move it side to side if it moves and feel sloppy your gears and link are worn out
them. No problem look at your clipper blade, you will see 3 screws remove the screw in the middle ONLY, The clipper blade will come off, replace with new blade put back the middle screw on and tighten
blades into place. There should be a black piece of metal at the rear end of the clipper blade whilst on the clippers, simply push this in towards the blade and at the same time pull the front edge of
remove the clipper blade did you notice a plastic part 1" long color gray, if you have lose this part your clipper blade not work. This is call a blade guide. Clipper blade installation, Place Plastic
...remove the hair from the blades, then lubricate with clipper oil. Make sure the blades are cutting clean dry hair, and if that still doesn't solve it try a different blade. If your clipper is under ...
...operating manual. It's best to do this soon before the motor burns out. If you feel that the blades are too clogged, it's easy to buy a replacement blade for around 1/3 the price of a new clipper
...speed from Amazon. The clippers worked fine with the no. 10 blade that was mounted on clipper. I removed the blade and now I can't get it back on or the 4f blade I also ordered. The blade
Usually answered in minutes!
356 Questions
246 Questions
187 Questions
140 Questions
159 Questions