Questions & Answers for: Cadillac how to remove the block

...remove the belt, then the coolant hoses and then the bolts securing the pump to the block. Note: there is one long bolt in the pump that can be removed thru the access hole in the body side rail. If ...

Ad

...block?? Remove the cables, neg. first then positive. Look down the side of the battery and u will see a bolt holding a block against the battery--remove the bolt then the block and the battery should ...

Ad

Question about 2001 DeVille

1 Answer

...block. 4. Remove the thermostat and gasket from the block and clean the location good with a wire brush. This ensures a good seal for the new gasket. Sometimes it helps to have a razor blade or other ...

Question about 2001 DeVille

1 Answer

Can an engine block heater be installed in a 1997 Cadillac Catera and if so how. If a block heater cannot be installed can an inline tank type heater be installed? the answer is yes, it can be ...

Question about 2004 CTS

3 Answers

...is located under the rear seat on the driver's side of the vehicle. The rear seat cushion must be removed to access the rear fuse block. See "Removing the Rear Seat Cushion" listed previously. To ...

Question about 2004 CTS

1 Answer

...remove old gasket, Clean very well the block and the pan, Then use some high tempiture silicone on pan and block let set about 5 min. Place your gasket over pan then press up to block, Start the four ...

Remove the axle nut- 36mm Use a hammer and block of wood to make sure the axle is loose. Remove the ABS wiring from the body Remove the 3 15mm bolts from the back side of the knuckle. Use the block of

Question about 1995 DeVille

1 Answer

...block. the threads for the head bolts loosen up in the block. making the heads loose so head gaskets leak.you have to remove the engine put in helicoils back in block to fix!!very exspensive

...coolant freezes to keep the block from cracking.. They also allow the sand from sand casting to be removed from the engine block casting. during manufacture.. Replacing them can be easy if its one ...

block. Remove the fastening bolt for the CKP sensor (1). Remove the CKP sensor and the O-ring seal from the engine block. Remove the CKP sensor pigtail. Observe the routing of the pigtail. Gently pull

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cadillac Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

Ronny Bennett Sr.
Ronny Bennett Sr.

Level 3 Expert

6988 Answers

Thomas Perkins
Thomas Perkins

Level 3 Expert

15088 Answers

Are you a Cadillac Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...