...base and check for/remove any imperfections in either with emory cloth. use a mineral oil based lubricant when reassembling and be careful not to overtighten the retaining nut.blow out the base after ...
Question about 10" Dual Bevel Sliding Compound Miter Saw
...remove the table from the base. generally you would have to remove both kerf boards and you will find a hex nut in the recessed area of the table, on a Makita is a 13MM remove it and then while ...
Question about 10" Dual Bevel Sliding Compound Miter Saw
base (156).... Remove the kerf board (108) and under you will see a big bolt, go ahead and remove this. Then there are 4 more bolts which take off the guide rule (117), this what your piece of wood is
...base off but no such luck. Thanks OK here is what you got, unplug saw and remove the fence. then remove the kerf boards and you will find a 13MM hex nut in the recess, remove it and pull the 2 parts ...
...to remove the center base. If yes with the center bolt removed it should go. If this can help view the parts diagram. ...
remove the table from the base and clean the surface, when you take it apart you will see what I am talking about. To do this first unplug the tool and remove the fence and kerf boards, under the kerf
Question about 10" Dual Bevel Sliding Compound Miter Saw
...remove turn base from base on a Makita LS1011 Slide Compound Saw? I have dismantled the saw and the turn base is still connected to the base but I can't see how to separate them. I have removed the ...
Question about 10" Dual Bevel Sliding Compound Miter Saw
...base so I can clean it and get it to rotate. I've squirted penetrating oil, without success to date. Any suggestions? The nut is not on the bottom, but under the snapout kerf plates. You remove the ...
...remove the Base? I want to screw back the clamp lever and paper clamp back to the base, but i can figure out how to remove the Base. Makita BO4900V Parts Breakdown Beginning with pos 6 4 screws and ...
Question about 9035 Finishing Sander Mak 9035
...remove the 4 screws holding the pad on it will pry off with a screwdriver (use caution and work your way around - the bearing sits in a holder on the base and is just stuck) Once you get that off, ...
Usually answered in minutes!
103 Questions
45 Questions
43 Questions
32 Questions