...Remove rear covers and using a 9/16 wrench lossen the four bolts that secure treadle assembly to base. Place a 3/4 inch piece of plywood or a 3/8 inch socket extension in between the treadles in the ...
...up the button which still would not release the pin. Finally I took the base (4 screws) off and removed the two metal brackets held on with two screws on the side that was stuck. It came apart ...
base of the machine. Remove the covers. Put the screws in the covers so you don't lose them. Note that the top screw is recessed deeply into a hole in the cover! Removing the side covers has exposed 4
...that won't allow leaving base? One of the weights is most likely a little off in the base. To unstick, remove the four screws on the base, then the two screws on clip. Handle will then
...Motor Control Board. If you tip the machine carefully onto it's left side with the side plastics removed you can see this
base. You may need to remove the weight plates from the base to accomplish this check. Remember to put each weight plate back in its appropriate location with the selection ****** facing away from the
...The grinding could also be roller bearings going bad. **For #3, and 4 above, you have but to remove the small belt that attaches to the motor (rubber, black, and small attached to pulleys),
...Remove right rear base plastic cover to allow access to LED board. Caution: Machine is on. Current is active!! 4. Locate LED D on the motor controller board. LED may be lit or unlit. 5. Manually ...
Usually answered in minutes!
41 Questions
38 Questions
33 Questions
33 Questions
17 Questions
