replace lid switch kenmore mod# 110.29902200 cannot figure out how to gain access to replcae lid switch remove the two screws in the top of the console they will be in the rear left anmd right side ...
Washer lid will not open after cycle The lid latch will not release after the cycle has finished. We tried busting it open, but nothing has worked. Any ideas? Thanks! suspect bad lid latch there is ...
Question about 24032\24036 Top Load Washer
Remove lid of top loading washing machine Kenmore 110.92575110 How do I take the lid off? It looks like there are four screws, two each side, but the rear two are blocked by the control console. There
Lid removal Did you find out how to remove your washing machine lid? We have the same problem, and did not see a solution posted. Do you know how to do it? If so can you please tell us? Thank you! ...
No Spin No Drain Washer finishes the wash cycle but wont drain or spin. Moved the switch to the rinse cycle and agitates and will fill with water.. at the end - no spin no draining - lid switch does ...
The washer does not drain the water or spin. Does the drain work when the spin cycle starts? pull end caps from both ends of back splash remove 2 screws flip control panel back...remove 2 clips(use ...
broken lid switch on washer The lid switch on my washing machine broke. I have ordered the part. Now I am wondering how to repair it. you must take the cabinet off by removeing the screws from the ...
Question about 24032\24036 Top Load Washer
My Kenmore 20902 washing machine lid is rusted. I... My Kenmore 20902 washing machine lid is rusted. If I order a replacement lid how do I remove the old lid and replace it? What tools are needed and ...
how do you get the lid off to replace the lid switch. remove the screws on each end of the control panel,some units you have to remove the end caps to get to the screws, then flip back the control ...
will not drain or go into spin cycle the lid switch is bad its there to keep the machine from running if you open the lid during operation,remove the control panel end caps,then there are 2 screws ...
Usually answered in minutes!
3,839 Questions
3,158 Questions
2,098 Questions
1,642 Questions
1,023 Questions