Questions & Answers for: remote signal receiver

Question about C27A24T 27" TV

1 Answer

...remote the signal pin should have inverted digital data (about 4.5 to 0). If you measure the signal pin and it is near zero volts, replace the receiver. If the signal pin is around 4.5 volts, replace ...

Ad

Question about DIRECTV Satellite Remote Control

1 Answer

Remote Satellite Won't Receive Signal My Satellite or receiver is not receiving signal even though i have the signal electronic finder. Worked just fine 30 miles north of here. Decatur Texas.76234 zip

Ad

Question about DIRECTV Satellite Remote Control

1 Answer

...the remote. i've wiped what i thought was the sensor area on the tv, but no luck!! it's really frustrating....can you help at all? Whatever circuit board the remote signal is received on is

Question about IR Remote Control

1 Answer

...remote now works. Vizio was emitting an infared signal that interfered with the Dish remote signals with these settings on. TV still works and looks just fine... But best of all Dish remote works

Question about Mr. Slim MXZ30TN Air Conditioner

1 Answer

...remote controller signal.) During individual unit control 1) Bad contact of transmission wire 2) Signal transmitting/receiving circuit is abnormal. 1) Check the transmission wire. 2) Check with ...

Question about Mr. Slim MXZ30TN Air Conditioner

1 Answer

...remote is sending out the signal or not you just point the remote at the digital camera's Lens (Digital Camera can detect IR), you should see flashing light on the camera's screen when any one of the ...

Question about Mr. Slim MXZ30TN Air Conditioner

1 Answer

...beep. When I take the batteries out of the receiver and put them back in, it will beep once Weak in transmission signal, either in remote or in PCB.Try with new remote. If no use you have to repair ...

Question about Mr. Slim MXZ30TN Air Conditioner

1 Answer

...remote or receiving signal problem with indoor. Check your remote with camera mobile and press on/off switch. If it's ultra light flashes, it's o.k. Then repair receiving signal in PCB.If no ultra ...

Question about Mr. Slim MXZ30TN Air Conditioner

1 Answer

signal in remote should be functioned properly. If any one of these, defective you can't operate by remote. In your case, it's receiving signal in PCB is weak or defective. You can repair/replace only

Question about 27148 Remote Control

0 Answer

but is does sometimes. I cannot identify the part in the fan which receives the signal. The part that receives the signal from the remote control is the receiver which is located in the motor housing

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Top Televison & Video Experts

Grand Canyon Tech
Grand Canyon Tech

Level 3 Expert

3867 Answers

Cindy Wells

Level 3 Expert

6688 Answers

 Grubhead
Grubhead

Level 3 Expert

5755 Answers

Are you a Televison & Video Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...