Questions & Answers for: relay timing belt marks

Question about 1986 Prelude

2 Answers

...timing pointer is at 15. Checked fuel rail, no fuel. checked voltage at fuel pump. no voltage! Put 12V power to pump and works fine. plenty of spark. So I am looking next at the ECU. but In the panel ...

Ad

Question about 1986 Prelude

2 Answers

...Timing Belt, cause your vehicle would have shut down as soon as it broke. It is possible that the water pump has gone bad. And it is run by the Timing Belt. So, it would only make sense to change the ...

Ad

Question about 2004 Tundra

1 Answer

...relay and starter will turn over but engine won't start. Its like we lost power to somthing. can you help? Recheck timing marks When you replace belt you must turn engine over a couple of times by ...

...belt was replaced without lining up the timing marks it wont run i have a 94 dodge shadow 2.5 car stop readed the codes an the auto shutdown relay came up , would the pick up have a effect on

Question about 1998 Legacy

1 Answer

...timing marks on it, they come in real handy, clamp the cams so they don't retract, before pulling the belt, put a pin in the belt tensioner hole if it has one, then pull the belt off, align all the ...

Question about 2001 Stratus

1 Answer

...timing marks were alined proply, tryed to crank car got fire but car will not crank, may not be getting fuel, is the a fuel shut off, if so where is it No fuel shut off, but you can jump the ...

timing belt. Or, you may have to loosen the tensioner pulley adjustment bolt to release the tension and the belt. Before proceeding, confirm which way the engine rotates during normal operation. (Pull

...relay. I have replaced the PCM/ECU camshaft position sensor troubleshot the engine control system completly to include the crankshaft position sensor all check out good and I still can not get the ...

Question about 2001 Stratus

1 Answer

...timing belt , got back together now relay for fuel pump relay does not make connection ( inside relay ) for power to fuel pump , new relays , no change . would it be the crankshaft sensor ? is that ...

...and other is the injector relay. Interface engine probley snapped a timing belt that’s why it won’t start and it sounds like it’s out of time because now it is out of time with a busted timing

Not finding what you are looking for?

Ask a Question

Usually answered in minutes!

Popular Products

Top Cars & Trucks Experts

ZJ Limited
ZJ Limited

Level 3 Expert

17989 Answers

john h

Level 3 Expert

29494 Answers

Arnie Burke
Arnie Burke

Level 3 Expert

7339 Answers

Are you a Cars & Trucks Expert? Answer questions, earn points and help others

Answer questions

Manuals & User Guides

Loading...