...( rod sticking out of rear wall inside oven ) should ohm out at 12-1300 ohms at room temp. the other possible cause is the heat relay on the control board is bad .this does not display a fault
...oven will not shut off unless I pull the breaker . BETTY Sounds like you have a sticking relay here is a link to the service manual on your unit ...
...oven that randomly overheats. It stays about 50 degrees above the desired temperature. It's like it kicks into broil or something and it happens too quick that dinner gets ruined a lot. 50 degrees is ...
Question about 40494 / 40495 / 40499 Electric Single Oven
...and seems to be heating up more. Answer for problem?? it is the bake relay sticking--on the eletronic oven control board.i tried to buy the relays but,no luck.must buy the eoc board-great ...
and this is sometimes...a good jarring will shake the contact loose. I don;t know if this is a electro-mechanical relay or a solidstate relay... either way... if it sticks once, it will stick again..
how do you get the fan off?? It just came on by iyself I THINK THE RELAY IS STICKING . CHECK THE FAN RELAY. THANKS PLEASE RATE MY WORK
Question about 30" Self-Cleaning Freestanding Electric Range - White-on-White
...the oven to see if it is going to high at times. If it stays the same then you have a relay on oven control which is your clock that is sticking and you will need to replace the clock.Hope this ...
...oven. After power is restored, reset the time and retest. Same identical problem result. Note that all other microwave functions are working. You likely have a sticking door switch or damaged door ...
Question about 30" Electric Self Clean Drop-In Range 4558
...It's usually caused by a sticking relay on the Electronic Oven Control (EOC) board. Either a sticking relay or a fused (welded-contacts) relay. In any event, you are looking at replacing the
Question about 30" Electric Self Clean Drop-In Range 4558
...everything--stove top elements and oven features. They are notorious for malfunctioning. The oven control board simply tells the relay board which relay to activate/de-activate. I hope I helped
Usually answered in minutes!
924 Questions
608 Questions
343 Questions
293 Questions